Both X-BULL generations are made from the same reinforced nylon and carry the same 10 tonne rating on flat ground, so the decision comes down to length, weight and how the rivet pattern holds up under repeated use. Gen 3.0 is longer and comes with a carry bag, Gen 2.0 is lighter and a touch more compact. Neither is the wrong choice, but one will suit your typical ground better.
| What you need | What to look at |
|---|---|
| Lightest tracks to carry up a dune or stow under a canopy | Gen 2.0, 4.7kg per pair |
| Longer boards to bridge deep ruts in clay or bull dust | Gen 3.0, 1060mm long |
| A bag to keep mud off the rest of your gear | Gen 3.0, carry bag included |
| Shortest footprint for a tight roof rack or drawer system | Gen 2.0, 910mm long |
What actually changes between Gen 2.0 and Gen 3.0
It helps to separate what's identical from what's different, because most of the build is shared across both generations.
Material and build
Both tracks use the same nylon mixture, described by X-BULL as giving toughness, tensile strength, compressive strength, anti-fatigue resistance and UV stability. Both use the U-shaped reinforced surface design, a cruciform underside that resists bending, lower ends shaped to double as a shovel, and an ergonomic carry handle. On paper, the materials and underlying structure are the same product family, just scaled differently.
Tread and rivet design
The spike pattern on the surface of both tracks is designed to bite into the tyre and stop side slip once the vehicle is moving. Where X-BULL draws a line between the two is the rivet arrangement itself. On its own product pages the brand puts it simply: Gen3.0 has a longer length and the unique rivet design is more wear resistant and lasts longer, while the advantage of Gen2.0 is the unique rivet arrangement and density, which makes the friction stronger and can be easily used by anyone. Independent reviewers who have compared the two side by side have also pointed out that the Gen 3 is reinforced with stiffening ribs making it stronger than the Gen 2, and has more rounded knobs for additional traction. In practice that means Gen 3.0 is the one built to take more repeat abuse from grit and rocks, while Gen 2.0 leans on a simpler, lighter pattern that still bites hard.
Length and weight
This is the clearest difference on the spec sheet. Gen 2.0 measures 910mm x 310mm x 60mm and weighs 4.7kg per pair, so a full two-pair kit (four boards) comes to about 9.4kg. Gen 3.0 measures 1060mm x 310mm x 60mm and weighs 7kg per pair, so the same two-pair kit comes to about 14kg. That's 150mm of extra length per board on Gen 3.0, roughly 16 percent longer, and close to 5kg more to carry and store across a full kit. Width and thickness are identical, so the extra length is the only dimension that changes the footprint in your canopy or drawer.
Load rating
Both generations are rated to 10 tonnes on flat ground. That figure doesn't change between them, so load capacity on its own isn't a reason to pick one over the other. Treat the rating as a flat-ground figure rather than a guarantee under every bog hole: a track spanning a sharp rut or sitting on an angle is working harder than the same track on level, firm ground, which is exactly where technique matters as much as the gear. Our guide to using recovery tracks covers digging in properly, chocking the other wheels and keeping bystanders clear before you drive out.

X-BULL Gen 2.0: lighter and shorter
The Gen 2.0 recovery tracks come in orange, in a two-pair kit of four boards, with the same U-shape and cruciform reinforcement described above. At 910mm long and 4.7kg per pair, they're the easier set to haul up a dune face by hand or sling into a smaller storage space, and the rivet density is still built to give strong friction under the tyre. This is the set to reach for if most of your recoveries are shorter, firmer-bottomed bogging, like soft sand on a beach access track or a wheel spinning in loose dirt at a camp site.

X-BULL Gen 3.0: longer and built for repeat abuse
The Gen 3.0 recovery tracks in black also ship as a two-pair kit, but each board is 1060mm long and the set includes a carry bag, which keeps caked mud and grit away from the rest of your recovery gear in the back of the vehicle. The extra 150mm of length matters most when the rut under the tyre is deeper than a few centimetres: a longer board bridges more of the gap and gives the tyre more contact length to climb out on, rather than the tyre spinning off the end before it's fully supported. The wear-resistant rivet design is also the better pick if you're regularly working the same set of tracks through abrasive, rocky mud rather than the occasional sand bog.
Comparing the two models
| Spec | Gen 2.0 (orange) | Gen 3.0 (black) |
|---|---|---|
| Length | 910mm | 1060mm |
| Width | 310mm | 310mm |
| Thickness | 60mm | 60mm |
| Weight per pair | 4.7kg | 7kg |
| Full kit weight (2 pairs, 4 boards) | about 9.4kg | about 14kg |
| Load rating | 10 tonnes, flat ground | 10 tonnes, flat ground |
| Carry bag included | No | Yes |
Full kit weights are the manufacturer's per-pair figure doubled for this two-pair listing, so treat them as close estimates rather than a figure off a set of scales.
Sand versus mud: which length and weight actually helps
Sand recoveries
Soft sand bogging is usually shallow and the vehicle is often still close to level, so the main job of the track is to give the tyre a firm, grippy surface to drive onto rather than bridge a deep gap. In that situation the shorter, lighter Gen 2.0 is easier to carry back and forth across dune faces or along a beach, and at 910mm it still gives the tyre plenty of length to climb onto before the tread runs out. If you air down for sand, our note on tyre pressure in the recovery tracks how-to guide is worth a read alongside whichever tracks you choose.
Mud recoveries
Mud and clay bogging tends to dig deeper ruts, and the vehicle is more often sitting nose-down or at an angle with the diff or chassis touching the ground. Here the extra 150mm on Gen 3.0 is doing real work, giving more board length to bridge the rut and more surface for the tyre to find grip before it reaches clear ground. The more wear-resistant rivet design is also the better match for grit and stones churned up in wet clay, which is harder on the tread than clean sand. The included bag is a small but genuine convenience here too, since muddy tracks are the ones you don't want touching your swag or fridge on the drive home.
Whichever set you run, they sit in our recovery tracks range alongside other X-BULL gear if you're building out a full kit with straps, a shovel and mounting hardware.
Frequently asked questions
Can I run one Gen 2.0 pair and one Gen 3.0 pair together?
Yes. Both share the same 310mm width and 60mm thickness and the same 10 tonne rating on flat ground, so they work under the same tyre widths without any compatibility issue. Some owners do exactly this, keeping the lighter Gen 2.0 pair for quick sand recoveries and the longer Gen 3.0 pair for deeper mud.
Are these tracks rated for snow as well as sand and mud?
X-BULL lists both generations with grips on the underside designed for sand, snow and mud non-slip use, under the same 10 tonne flat-ground rating. The tread pattern doesn't change by surface, so the same board works across all three conditions.
Do the Gen 2.0 tracks come with a carry bag like the Gen 3.0 set?
No. The Gen 2.0 two-pair kit ships as four boards without a bag, while the Gen 3.0 two-pair kit includes a carry bag as standard. If keeping muddy boards separate from the rest of your gear matters to you, factor that into the choice alongside the length difference.
What does the 10 tonne rating actually mean for my vehicle?
It's the load capacity the manufacturer states for the track sitting on flat ground, not a guarantee under every angle or surface a bogged vehicle might be sitting at. Always follow the product manual for placement and never stand near a tyre under load, and check our guide on using recovery tracks for the proper digging-in and clearance steps before you drive out.
Still not sure which one suits you?
Tell us what you drive, how heavy it's loaded and where you get stuck most, sand, mud, snow or a bit of everything, and we can point you to the right pair. Get in touch or browse the full recovery tracks range to see both generations side by side.
